Question
a.
stopped at the banks of the river
b.
stopped at the edge of the river
c.
drawn across the water
d.
drawn by parabolic curves having their vertex at the centre of the water.
Posted under Surveying Civil Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In case of a double line river, contours are
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Pick up the correct statement from the following
View solution
Q. While working on a plane table, the correct rule is :
View solution
Q. Contours of different elevations may cross each other only in the case of
View solution
Q. Determining the difference in elevation between two points on the surface of the earth, is known as
View solution
Q. In geodetic surveys higher accuracy is achieved, if
View solution
Q. If Δ is the angle of deflection of a simple curve of radius R, the length of its long chord, is
View solution
Q. Pick up the correct statement from the following :
View solution
Q. A transit is oriented by setting its vernier A to read the back azimuth of the preceding line. A back sight on the preceding transit station taken and transit is rotated about its vertical axis. The vernier A reads
View solution
Q. The bearing of line AB is 152° 30' and angle ABC measured clockwise is 124° 28'. The bearing of BC is
View solution
Q. The representation of general topography of a very flat terrain is possible only
View solution
Q. The lens equation 1/f = 1/f1 + 1/f2 is applicable
View solution
Q. The surface of zero elevation around the earth, which is slightly irregular and curved, is known as
View solution
Q. If the whole circle bearing of a line is 270°, its reduced bearing is
View solution
Q. For taking offsets with an optical square on the right hand side of the chain line, it is held
View solution
Q. A level when set up 25 m from peg A and 50 m from peg B reads 2.847 on a staff held on A and 3.462 on a staff held on B, keeping bubble at its centre while reading. If the reduced levels of A and B are 283.665 m and 284.295 m respectively, the collimation error per 100 m is
View solution
Q. If the declination of the needle is 10° W
View solution
Q. The method generally preferred to for contouring an undulating area, is
View solution
Q. The 10 mm markings on a levelling staff placed at 20 m are separated by
View solution
Q. Pick up the correct statement from the following :
View solution
Q. If 50 m point of a 100 m tape is 50 cm off line, and 50 m sections are straight, an error is generated equal to
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
