Question
a.
liquid state
b.
plastic state
c.
semi solid state
d.
all of these.
Posted under Civil Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A decrease in water content results in a reduction of the volume of a soil in
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Pick up the correct statement from the following:
View solution
Q. Number of piles required to support a column, is
View solution
Q. The soil moisture driven off by heat, is called
View solution
Q. If the specific gravity of a soil particle of 0.05 cm diameter is 2.67, its terminal velocity while settling in distilled water of viscosity, 0.01 poise, is
View solution
Q. The direct shear test suffers from the following disadvantage:
View solution
Q. For a clay slope of height of 10 m, the stability number is 0.05, γ = 2.0 t/m³, C = 2.5 t/m², the critical height of the slope of the soil, is
View solution
Q. If σ0' and σ' represent initial and increased pressure ; e0 and e void ratios corresponding to initial and increased pressure ; and C0 the compression index (dimensionless), then, the virgin compression curve as expressed by Terzaghi empirical formula is
View solution
Q. The equation τ = C + σ tan φ is given by
View solution
Q. You are given a sample of soil containing coarse grains to determine its water content, you will use
View solution
Q. Pick up the incorrect statement from the following:
View solution
Q. The maximum load carried by a pile, when it continues to sink without further increase of load, is known as
View solution
Q. The soil which contains finest grain particles, is
View solution
Q. The angle between the directions of the failure and the major principal plane, is equal to
View solution
Q. The compressibility of clays, is caused due to:
View solution
Q. A phreatic line is defined as the line within a dam section below which there are
View solution
Q. The ratio of the difference between the void ratio of the soil in its loosest state and its natural void ratio (e) to the difference between the void ratios in the loosest and fully dense state, is generally termed as
View solution
Q. Pick up the correct statement from the following:
View solution
Q. According to the Indian Standards the specific gravity is the ratio of the unit weight of soil solids to that of water at a temperature of
View solution
Q. The compression index of a soil
View solution
Q. Pick up the correct statement from the following:
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!