Q. For a clay slope of height of 10 m, the stability number is 0.05, γ = 2.0 t/m³, C = 2.5 t/m², the critical height of the slope of the soil, is

View solution

Q. If σ0' and σ' represent initial and increased pressure ; e0 and e void ratios corresponding to initial and increased pressure ; and C0 the compression index (dimensionless), then, the virgin compression curve as expressed by Terzaghi empirical formula is

View solution

Q. The equation τ = C + σ tan φ is given by

View solution

Q. You are given a sample of soil containing coarse grains to determine its water content, you will use

View solution

Q. Pick up the incorrect statement from the following:

View solution

Q. The maximum load carried by a pile, when it continues to sink without further increase of load, is known as

View solution

Q. The soil which contains finest grain particles, is

View solution

Q. The angle between the directions of the failure and the major principal plane, is equal to

View solution

Q. The compressibility of clays, is caused due to:

View solution

Q. A phreatic line is defined as the line within a dam section below which there are

View solution

Q. The ratio of the difference between the void ratio of the soil in its loosest state and its natural void ratio (e) to the difference between the void ratios in the loosest and fully dense state, is generally termed as

View solution

Q. Pick up the correct statement from the following:

View solution

Q. According to the Indian Standards the specific gravity is the ratio of the unit weight of soil solids to that of water at a temperature of

View solution

Q. The compression index of a soil

View solution

Q. Pick up the correct statement from the following:

View solution

Q. For a homogeneous earth dam 50 m high having 2 m free broad, a flow net was constructed and the results were : Number of potential drops = 2.4 Number of flow channels = 0.4. If coefficiency of permeability of the dam mateiral is 3 x 10^-3 cm³/sec, the discharge per metre length of dam, is

View solution

Q. For shear strength, triaxial shear test is suitable because

View solution

Q. Pick up the correct statement from the following :

View solution

Q. The ratio of settlement at any time 't' to the final settlement, is known as

View solution

Q. The Westergaard analysis is used for

View solution