Question

Negative skin friction on piles

a.

is caused due to relative settlement of the soil

b.

is caused in soft clays

c.

decreases the pile capacity

d.

all of the above.

Posted under Civil Engineering

Answer: (d).all of the above.

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Negative skin friction on piles

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The ultimate bearing capacity of a soil, is

Q. Transporting and redepositing soils, is done by

Q. A moist soil sample of volume 60 cc. weighs 108 g and its dried weight is 86.4 g. If its absolute density is 2.52, the degree of saturation is

Q. Pick up the incorrect statement from the following:

Q. The maximum water content at which a reduction in water content does not cause a decrease in volume of a soil mass, is known

Q. A sample of saturated soil has 30% water content and the specific gravity of soil grains is 2.6. The dry density of the soil mass in g/cm³, is

Q. The specific gravity of sands, is approximately

Q. If the coefficients of volume change and compressibility of a soil sample are respectively 6.75 x 10^-2 and 3 x 10^-2, the void ratio of the soil sample, is

Q. A stratum of clay 2 m thick will get consolidated 80% in 10 years. For the 80% consolidation of 8 m thick stratum of the same clay, the time required is

Q. The maximum net pressure intensity causing shear failure of soil, is known

Q. The factor which affects the compaction, is

Q. The compression resulting from a long term static load and consequent escape of pore water, is known as

Q. Soil classification of composite soils, exclusively based on the particle size distribution, is known

Q. The vane shear test is used for the in-situ determination of the undrained strength of the intact fully saturated

Q. The specific gravity of quartz, is

Q. If the cohesive force, (c), is 1.5 t/m², the density (γ) of the soil is 2.0 t/m³, factor of safety (F) is 1.5 and stability factor (Sn) is 0.05, the safe height of the §lope, is

Q. Pick up the correct statement from the following:

Q. Through a point in a loaded soil, the principal stress is maximum on

Q. Maximum size of clay particles, is :

Q. The capillary rise of water

Recommended Subjects

Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!