Q. The total weight of a pycnometer with water and oven dried soil 20 (g) is 1600 g. The pycnometer filled with water alone weighs 1500 g. The specific gravity of the soil, is

View solution

Q. The consolidation time for soils

View solution

Q. According to IS : 2720 - 1965, the composition of a dispersing solution used in pipette analysis for determining the size of particles, is

View solution

Q. Cohesive soils are generally

View solution

Q. If the coefficient of the active pressure Ka is 1/3, the coefficient of passive pressure Kp, is

View solution

Q. The inventor of the term soil mechanics, was

View solution

Q. Compression of soil occurs rapidly if voids are filled with

View solution

Q. A saturated soil sample has water content of 40% and specific gravity of soil particles 2.7. The void ratio of the soil, is

View solution

Q. For testing a saturated clay for shear strength, the test recommended, is

View solution

Q. The critical exist gradient of seepage water in soils, increases with

View solution

Q. If drainage is permitted throughout the test, during the application of both normal, and shear stresses so that full consolidation occurs and no excess pore pressure is set up at any stage of the test, is known as

View solution

Q. A soil sample of mass specific gravity 1.92, has a moisture content 30%. If the specific gravity of solids is 2.75, the degree of saturation, is

View solution

Q. For slopes of limited extent the surface of slippage, is usually along

View solution

Q. For a base failure of a slope, depth factor

View solution

Q. A critical hydraulic gradient may occur when

View solution

Q. A clay subjected to pressure in excess to its present over-burden, is said to be

View solution

Q. The total active earth pressure due to dry back fill with no surcharge, acts at H/3 above the base of the wall and is directly proportional to

View solution

Q. Stoke's law does not hold good if the size of particle is smaller than

View solution

Q. In a purely cohesive soil, the critical centre lies at the intersection of

View solution

Q. The angle of internal friction, is least for

View solution