Question
a.
Kray
b.
Dr. Karl Terzaghi
c.
Leygue
d.
Fellenius.
Posted under Civil Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The inventor of the term soil mechanics, was
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Compression of soil occurs rapidly if voids are filled with
View solution
Q. A saturated soil sample has water content of 40% and specific gravity of soil particles 2.7. The void ratio of the soil, is
View solution
Q. For testing a saturated clay for shear strength, the test recommended, is
View solution
Q. The critical exist gradient of seepage water in soils, increases with
View solution
Q. If drainage is permitted throughout the test, during the application of both normal, and shear stresses so that full consolidation occurs and no excess pore pressure is set up at any stage of the test, is known as
View solution
Q. A soil sample of mass specific gravity 1.92, has a moisture content 30%. If the specific gravity of solids is 2.75, the degree of saturation, is
View solution
Q. For slopes of limited extent the surface of slippage, is usually along
View solution
Q. For a base failure of a slope, depth factor
View solution
Q. A critical hydraulic gradient may occur when
View solution
Q. A clay subjected to pressure in excess to its present over-burden, is said to be
View solution
Q. The total active earth pressure due to dry back fill with no surcharge, acts at H/3 above the base of the wall and is directly proportional to
View solution
Q. Stoke's law does not hold good if the size of particle is smaller than
View solution
Q. In a purely cohesive soil, the critical centre lies at the intersection of
View solution
Q. The angle of internal friction, is least for
View solution
Q. In non-cohesive soil in passive state of plastic equilibrium
View solution
Q. In active state of plastic equilibrium in a non cohesive soil with horizontal ground surface
View solution
Q. The zero atmospheric pressure is at
View solution
Q. A soil mass coated with a thin layer of paraffin weighs 460 g. When immersed, it displaces 299 cc of water. The weight of paraffin is 10 g. If specific gravity of solids is 2.5 and that of paraffin 0.9, the void ratio of soil, is
View solution
Q. Pick up the incorrect definition from the following:
View solution
Q. In a fow net
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!