Q. The ratio of emax and emin of silty sand, is

View solution

Q. A flow net may be utilised for the determination of

View solution

Q. The neutral stress in a soil mass is

View solution

Q. If voids ratio is 0.67, water content is 0.188 and specific gravity is 2.68, the degree of saturation of the soil, is

View solution

Q. If water content of a soil is 40%, G is 2.70 and void ratio is 1.35, the degree of saturation is

View solution

Q. The specific gravity of Calcite is

View solution

Q. The ratio of volume of air voids to the volume of total voids, is known as

View solution

Q. A plane inclined at an angle φ to the horizontal at which the soil is expected to stay in the absence of any lateral support, is known as

View solution

Q. Tergazhi's theory of one dimensional consolidation assumes

View solution

Q. Pick up the correct statement from the following:

View solution

Q. A failure wedge develops if a retaining wall

View solution

Q. For determining the ultimate bearing capacity of soil, the recommended size of a square bearing plate to be used in load plate test should be 30 to 75 cm square with a minimum thickness of

View solution

Q. The water content in a soil sample when it continues to loose weight without loosing the volume, is called

View solution

Q. When a cohesionless soil attains quick condition, it looses

View solution

Q. Sedimentation analysis is based on the assumption:

View solution

Q. The maximum pressure which a soil can carry without shear failure, is called

View solution

Q. For general engineering purposes, soils are classified by

View solution

Q. If there is no impervious boundary at the bottom of a hydraulic structure, stream lines tend to follow :

View solution

Q. The change of moisture content of soils, changes the

View solution

Q. Pick up the correct statement from the following:

View solution