Question

The depth of the centre of pressure on a vertical rectangular gate (4 m wide, 3 m high) with water upto top surface, is

a.

1.0 m

b.

1.5 m

c.

2.0 m

d.

2.5 m.

Posted under Civil Engineering

Answer: (c).2.0 m

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. The depth of the centre of pressure on a vertical rectangular gate (4 m wide, 3 m high) with water upto top surface, is

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The differential equation dp/ρ + gdz + vdv = 0 for a fluid motion is suggested by

Q. An open container filled with water is moved vertically downward with a uniform linear acceleration. The pressure at its bottom will be

Q. For uniform flow in canals

Q. If H is height of the liquid above the sill, the effect of end contractions, according to Francis formula, is

Q. Pick up the correct statement from the following :

Q. The pressure less than atmospheric , pressure, is known

Q. A rise or fall of liquid in a glass tube of a very small diameter when dipped is

Q. To measure very low pressure, we use

Q. If v1 and v2 are the velocities of flow before and after sudden enlargement in a pipe, the head loss given by Carnot and Borda equation, is

Q. Equation of continuity of fluids is applicable only if

Q. The flow in open channel is said to be critical if the Froude number is :

Q. An orifice is an opening in a vessel with

Q. The imaginary line drawn such that the tangents at its all points indicate the direction of the velocity of the fluid particles at each point, is called

Q. To avoid the tendency of separation of liquid flow, the most suitable ratio of the diameters of the throat and the pipe, is

Q. The instrument used for measuring the velocity of flow, is known as

Q. For a long pipe, the head loss

Q. On a flow net diagram, the distance between two consecutive steam lines at two successive sections are 1 cm and 0.5 cm respectively. If the velocity at the first section is 1 m/sec, the velocity at the second is

Q. The flow is called rotational if its velocity normal to the plane of area is equal to

Q. In flowing liquids pitot tubes are used measure

Q. Capillary rise of water is

Recommended Subjects

Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!