Question
a.
glazed bricks sewers
b.
cast iron sewers
c.
cement concrete sewers
d.
stone ware sewers.
Posted under Civil Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In sewers the highest non-scouring velocity is achieved in
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In sewage having fully oxidised organic matter, the nitrogen exists in the form of
View solution
Q. It is customary to design a sewer for D.W.F. on the basis of
View solution
Q. During preliminary treatment of a sewage
View solution
Q. Pick up the correct statement from the following :
View solution
Q. The most dangerous pollutant in vehicular emissions is
View solution
Q. If the depletion of oxygen is found to be 2.5 mg/litre after incubating 2.5 ml of sewage diluted to 250 ml for 5 days at 20°C, B.O.D. of the sewage is
View solution
Q. The clarigesters are
View solution
Q. Rate of flow of sewage is generally assumed
View solution
Q. Maximum permissible velocity 1.5 m/sec, is adopted in drains
View solution
Q. For design purposes, the normal rate of infiltration of ground water into the sewer, is
View solution
Q. The effluent of a septic tank is
View solution
Q. The drainage area of a town is 12 hectares. Its 40% area is hard pavement (K = 0.85), the 40% area is unpaved streets (K = 0.20) and the remaining is wooded areas (K = 0.15). Assuming the time of concentration for the areas as 30 minutes and using the formula Ps = 900/t+60 the maximum run off is
View solution
Q. The detention period for plain sedimentation water tanks, is usually
View solution
Q. To prevent settling down of sewage both at the bottom and on the sides of a large sewer, self-cleaning velocity recommended for Indian conditions, is
View solution
Q. Pick up the correct statement from the following :
View solution
Q. In sewers the gas generally found, is
View solution
Q. A sewer running partially full and hurried with back filled, fails in compression due to
View solution
Q. A manhole is classified as shallow if its depth is between
View solution
Q. The ratio of the diameter of a circular section and the side of a square section hydraulically equivalent, is
View solution
Q. Pick up the correct statement from the following :
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!