Q. Minimum spacing between horizontal parallel reinforcement of different sizes, should not be less than

View solution

Q. In a prestressed member it is advisable to use

View solution

Q. The ratio of the breadth to effective depth of a beam is kept

View solution

Q. Spacing of stirrups in a rectangular beam, is

View solution

Q. If the width of the foundation for two equal columns is restricted, the shape of the footing generally adopted, is

View solution

Q. After prestressing process is completed, a loss of stress is due to

View solution

Q. The minimum head room over a stair must be

View solution

Q. In case the factor of safety against sliding is less than 1.5, a portion of slab is constructed downwards at the end of the heel slab, which is known as

View solution

Q. The diameter of the column head support a flat slab, is generally kept

View solution

Q. The steel generally used in R.C.C. work, is

View solution

Q. The minimum thickness of a flat slab is taken

View solution

Q. According to I.S. : 456, slabs which span in two directions with corners held down, are assumed to be divided in each direction into middle strips and edge strips such that the width of the middle strip, is

View solution

Q. Minimum spacing between horizontal parallel reinforcement of the same size should not be less than

View solution

Q. Columns may be made of plain concrete if their unsupported lengths do not exceed their least lateral dimension

View solution

Q. An R.C.C. column is treated as short column if its slenderness ratio is less than

View solution

Q. Lapped splices in tensile reinforcement are generally not used for bars of size larger than

View solution

Q. An R.C.C. beam of 6 m span is 30 cm wide and has a lever arm of 55 cm. If it carries a U.D.L. of 12 t per m and allowable shear stress is 5 kg/cm², the beam

View solution

Q. In a slab, the pitch of the main reinforcement should not exceed its effective depth

View solution

Q. The maximum ratio of span to depth of a slab simply supported and spanning in one direction, is

View solution

Q. The load stress of a section can be reduced by

View solution