Q. The diameter of the column head support a flat slab, is generally kept

View solution

Q. The steel generally used in R.C.C. work, is

View solution

Q. The minimum thickness of a flat slab is taken

View solution

Q. According to I.S. : 456, slabs which span in two directions with corners held down, are assumed to be divided in each direction into middle strips and edge strips such that the width of the middle strip, is

View solution

Q. Minimum spacing between horizontal parallel reinforcement of the same size should not be less than

View solution

Q. Columns may be made of plain concrete if their unsupported lengths do not exceed their least lateral dimension

View solution

Q. An R.C.C. column is treated as short column if its slenderness ratio is less than

View solution

Q. Lapped splices in tensile reinforcement are generally not used for bars of size larger than

View solution

Q. An R.C.C. beam of 6 m span is 30 cm wide and has a lever arm of 55 cm. If it carries a U.D.L. of 12 t per m and allowable shear stress is 5 kg/cm², the beam

View solution

Q. In a slab, the pitch of the main reinforcement should not exceed its effective depth

View solution

Q. The maximum ratio of span to depth of a slab simply supported and spanning in one direction, is

View solution

Q. The load stress of a section can be reduced by

View solution

Q. Pick up the correct statement from the following:

View solution

Q. The allowable tensile stress in mild steel stirrups, reinforced cement concrete, is

View solution

Q. If longitudinally spanning stairs are casted along with their landings, the maximum bending moment per metre width, is taken as

View solution

Q. If A is the sectional area of a prestressed rectangular beam provided with a tendon prestressed by a force P through its centroidal longitudinal axis, the compressive stress in concrete, is

View solution

Q. According to I.S.: 456, 1978 the thickness of reinforced concrete footing on piles at its edges, is kept less than

View solution

Q. A pre-stressed concrete member is preferred because

View solution

Q. A very comfortable type of stairs is

View solution

Q. For M 150 grade concrete (1:2:4) the moment of resistance factor is

View solution