Q. For calculating the length of curve lead (C.L.), the correct formula is

View solution

Q. The standard dimensions of a wooden sleeper for M.G. railway track are

View solution

Q. The standard width of ballast for B.G.track in Indian Railways, is kept

View solution

Q. The angle between the gauge faces of the stock rail and tongue rail, is called

View solution

Q. Top surface of steel sleepers, is

View solution

Q. Indian Railways detects the rail flow by

View solution

Q. The rail section which is not used on Indian Broad Gauge tracks, is

View solution

Q. Ballast packed below and around the sleepers to transfer the load from sleepers to formation, generally consists of

View solution

Q. A wing rail is renewed or reconditioned if its maximum vertical wear is

View solution

Q. A triangle used for turning the face of locomotives, consists of

View solution

Q. Monnier, the inventor of R.C.C., suggested the introduction of reinforced cement concert sleepers for the railways in

View solution

Q. If D is the distance between the parallel sidings and α is the angle of crossing, the distance between the noses of crossing measured parallel to the gathering line, is

View solution

Q. Regional Indian railways use different types of sleepers according to their

View solution

Q. Width of the top portion of a flat footed, rail, is

View solution

Q. For providing the required tilt of rails, adazing of wooden sleepers, is done for

View solution

Q. The life of a wooden sleeper depends upon

View solution

Q. The spread between the point and splice rails at a distance of 4.25 rn is 50 cm. The size of the crossing is

View solution

Q. Minimum packing space provided between two sleepers, is between

View solution

Q. The place where a railway line and a road cross each other at the same level, is known as

View solution

Q. On Indian Railways standard length of rails for B.G. track, is

View solution