Q. Sand may be used as ballast for

View solution

Q. Cast iron sleeper, is

View solution

Q. Track construction involves preparation of

View solution

Q. In permanent way, ballast

View solution

Q. On either side of the centre line of rails, a cant of 1 in 20 in the sleeper is provided for a distance of

View solution

Q. If D is the distance between parallel tracks G is the gauge and α is angle of crossings, the distance between theoretical noses of two crossings measured parallel to tracks, is

View solution

Q. Minimum composite sleeper index for wooden sleepers used over bridge girders, is

View solution

Q. In a diamond crossing, number of noses are

View solution

Q. If the stock rails are B.H. rails, the type of switch generally provided, is

View solution

Q. Bending of rail ends due to loose packing under a joint and loose fish Bolts, is known

View solution

Q. Packing of ballast is done

View solution

Q. If the standard length of a B.G. crossing is 597 cm, the number of crossing, is

View solution

Q. Rails are fixed on steel sleepers

View solution

Q. If a is average number of peaks more than 10 mm of uneveness per kilometre, b is average number peaks more than 6 mm for gauge variation per kilometre and c is average number of peaks more than 2 mm twist per metre, then composite current recording index (Ic), as recommended by Indian Northern Railways, is

View solution

Q. Pick up the correct statement from the following:

View solution

Q. The standard width of ballast for M.G. track in Indian Railways, is kept

View solution

Q. To prevent creep in rails, the steel sleepers are fixed with rails by clips, bolts and

View solution

Q. The standard dimensions of a wooden sleeper for a B.G. railway track are

View solution

Q. In Indian railways, the ratio of axle load and weight of rail, is

View solution

Q. On Broad Gauge main lines with maximum traffic loads, the rail section preferred to, is

View solution