Q. If a shaft is rotating N revolutions per minute with an applied torque T kg-m, the horse power being transmitted by the shaft, is

View solution

Q. The energy stored in a beam of length L subjected to a constant B.M. is

View solution

Q. The force in DB of the truss shown in below figure is

View solution

Q. The length of a column which gives the same value of buckling load by Euler and Rankine-Gordon formula, is equal to

View solution

Q. The direction of the reaction at support B of a truss shown in below figure will be

View solution

Q. The reaction at support A of the beam shown in below figure, is

View solution

Q. The B.M. of a cantilever beam shown in below figure at A, is

View solution

Q. If a member carries a tensile force P on its area of cross-section A, the normal stress introduced on an inclined plane making an angle θ with its transverse plane, is

View solution

Q. For a channel section, the shear centre lies at a distance of

View solution

Q. If the normal cross-section A of a member is subjected to tensile force P, the resulting normal stress in an oblique plane inclined at angle θ to transverse plane will be

View solution

Q. The nature of the stress in horizontal members of the truss shown in below figure may be

View solution

Q. The structure shown in below figure is stable, if

View solution

Q. The greatest eccentricity which a load W can have without producing tension on the cross-section of a short column of external diameter D and internal diameter d, is

View solution

Q. The ratio of the moments of resistance of a solid circular shaft of diameter D and a hollow shaft (external diameter D and internal diameter d), is

View solution

Q. A cantilever carries is uniformly distributed load W over its whole length and a force W acts at its free end upward. The net deflection of the free end will be

View solution

Q. For a given material, if E, C, K and m are Young's modulus, shearing modulus, bulk modulus and poisson ratio, the following relation does not hold good

View solution

Q. In the given below figure, the rivets with maximum stress, are :

View solution

Q. For the beam shown in below figure, the maximum positive bending moment is nearly equal to negative bending moment when L1 is equal to

View solution

Q. A composite member shown in below figure was formed at 25°C and was made of two materials a and b. If the coefficient of thermal expansion of a is more than that of b and the composite member is heated upto 45°C, then

View solution

Q. Shear deflection of a cantilever of length L, cross sectional area A and shear modulus G, under a concentrated load W at its free end, is

View solution