Q. For a channel section, the shear centre lies at a distance of

View solution

Q. If the normal cross-section A of a member is subjected to tensile force P, the resulting normal stress in an oblique plane inclined at angle θ to transverse plane will be

View solution

Q. The nature of the stress in horizontal members of the truss shown in below figure may be

View solution

Q. The structure shown in below figure is stable, if

View solution

Q. The greatest eccentricity which a load W can have without producing tension on the cross-section of a short column of external diameter D and internal diameter d, is

View solution

Q. The ratio of the moments of resistance of a solid circular shaft of diameter D and a hollow shaft (external diameter D and internal diameter d), is

View solution

Q. A cantilever carries is uniformly distributed load W over its whole length and a force W acts at its free end upward. The net deflection of the free end will be

View solution

Q. For a given material, if E, C, K and m are Young's modulus, shearing modulus, bulk modulus and poisson ratio, the following relation does not hold good

View solution

Q. In the given below figure, the rivets with maximum stress, are :

View solution

Q. For the beam shown in below figure, the maximum positive bending moment is nearly equal to negative bending moment when L1 is equal to

View solution

Q. A composite member shown in below figure was formed at 25°C and was made of two materials a and b. If the coefficient of thermal expansion of a is more than that of b and the composite member is heated upto 45°C, then

View solution

Q. Shear deflection of a cantilever of length L, cross sectional area A and shear modulus G, under a concentrated load W at its free end, is

View solution

Q. An open-ended cylinder of radius r and thickness t is subjected to internal pressure p. The Young's modulus for the material is E and Poisson's ratio is μ. The longitudinal strain is

View solution

Q. The force in BD of the truss shown in below figure is :

View solution

Q. The bending moment at E for the structure shown in below figure, is

View solution

Q. Euler's formula states that the buckling load P for a column of length l, both ends hinged and whose least moment of inertia and modulus of elasticity of the material of the column are I and E respectively, is given by the relation

View solution

Q. The force in the member DE of the truss shown in below figure will be

View solution

Q. If a member is subjected to a tensile force P, having its normal cross-section A, the resulting shear stress in an oblique plane inclined at an angle θ to its transverse plane, is

View solution

Q. If a solid shaft is subjected to a torque T at its end such that maximum shear stress does not exceed fz the diameter of the shaft will be

View solution

Q. In a simply supported beam L with a triangular load W varying from zero at one end to the maximum value at the other end, the maximum bending moment is

View solution