Q. In plastic analysis, the shape factor for a triangular section, is

View solution

Q. Pick up the correct statement from the following:

View solution

Q. The tangential component of stress on an plane inclined θ° to the direction of the force, may be obtained by multiplying the normal stress by

View solution

Q. There are two hinged semicircular arches A, B and C of radii 5 m, 7.5 m and 10 m respectively and each carries a concentrated load W at their crowns. The horizontal thrust at their supports will be in the ratio of

View solution

Q. A spring of mean radius 40 mm contains 8 action coils of steel (N = 80000 N/mm²), 4 mm in diameter. The clearance between the coils being 1 mm when unloaded, the minimum compressive load to remove the clearance, is

View solution

Q. A load of 1960 N is raised at the end of a steel wire. The minimum diameter of the wire so that stress in the wire does not exceed 100 N/mm² is :

View solution

Q. In plastic analysis, the shape factor for rectangular section, is

View solution

Q. In case of a simply supported rectangular beam of span L and loaded with a central load W, the length of elasto-plastic zone of the plastic hinge, is

View solution

Q. A truss containing j joints and m members, will be a simple truss if

View solution

Q. The assumption in the theory of bending of beams, is :

View solution

Q. The shape factor of standard rolled beam section varies from

View solution

Q. Shear strain energy theory for the failure of a material at elastic limit, is due to

View solution

Q. The point of contraflexure is the point where

View solution

Q. The normal component of a force inclined through θ° is obtained by multiplying the force by

View solution

Q. If ΣH and ΣV are the algebraic sums of the forces resolved horizontally and vertically respectively, and ΣM is the algebraic sum of the moments of forces about any point, for the equilibrium of the body acted upon

View solution

Q. For determining the support reactions at A and B of a three hinged arch, points B and C are joined and produced to intersect the load line at D and a line parallel to the load line through A at D'. Distances AD, DD' and AD' when measured were 4 cm, 3 cm and 5 cm respectively. The angle between the reactions at A and B is

View solution

Q. Pick up the incorrect statement from the following : The torsional resistance of a shaft is directly proportional to

View solution

Q. A material is said to be perfectly elastic if

View solution

Q. Beams composed of more than one material, rigidly connected together so as to behave as one piece, are known as

View solution

Q. Pick up the correct statement from the following:

View solution