Q. The portion of a brick cut across the width, is called

View solution

Q. The concrete slump recommended for beams and slabs ; is

View solution

Q. The member which is placed horizontally to support common rafter of a sloping roof, is

View solution

Q. Pick up the correct statement from the following:

View solution

Q. The angular steps used for changing direction of the stairs, are called

View solution

Q. During percussion drilling

View solution

Q. In English garden wall bond

View solution

Q. A projecting piece usually provided to support a truss, is

View solution

Q. The line of intersection of the surfaces of a sloping roof forming an external angle exceeding 180°, is

View solution

Q. Grillage foundation

View solution

Q. The exterior angle between outer faces of a wall, is known as

View solution

Q. In jack arch floor, the rise is kept

View solution

Q. While designing a stair, the product of rise and going is approximately kept equal to

View solution

Q. For constructing a terrazo floor. Pick up the incorrect statement from the following :

View solution

Q. Stud(s) of a common wooden partition

View solution

Q. Pick up the correct statement from the following :

View solution

Q. Pick up the commonly adopted geophysical method in civil engineering from the following :

View solution

Q. To ensure that supporting area of an offset footing of a boundary wall is fully compressive, the C.G. of load must act

View solution

Q. The 9 cm x 9 cm side of a brick as seen in the wall face, is generally known as

View solution

Q. The taper of precast concrete pile should not be more than

View solution