Q. A roof which slopes in four directions, is called

View solution

Q. The formWork including the props can be removed from beams, only after

View solution

Q. The type of bond in a brick masonry containing alternate courses of stretchers and headers, is called

View solution

Q. While investigating the site, a thick layer of fairly firm clay over a deep layer of soft clay is encountered. In such a situation, the following type of foundation is useful :

View solution

Q. The concrete slump recommended for columns, is

View solution

Q. The inner section of a cavity wall, is generally known as

View solution

Q. The inclined support at the ends of treads and rises of a stair, is known as

View solution

Q. The depth of concrete bed of the foundation depends upon

View solution

Q. The vertical side member of a shutter frame, is known

View solution

Q. The brick laid with its length parallel to the face of a wall, is a known as

View solution

Q. Couple roof is used for spans

View solution

Q. If the depth of an excavation is 20 metres, number of single stage well points to be installed at various levels, is

View solution

Q. The minimum distance between the centres of bulb of diameter du, of a multi under reamed piles, is

View solution

Q. The method of moving each brick through a small horizontal distance before it is finally laid in any brick wall and pressing it by means of brick hammer, is known as

View solution

Q. The stone whose crushing strength is maximum, is

View solution

Q. The vertical member running through middle of a shutter frame, is

View solution

Q. In grillage foundations, distance between flanges of grillage beams, is kept

View solution

Q. Herringbone bond is used for

View solution

Q. A cut in frame of a door to receive the shutter, is called

View solution

Q. The alignment of a cross joint along the plumb line is

View solution