Q. The vertical side member of a shutter frame, is known

View solution

Q. The brick laid with its length parallel to the face of a wall, is a known as

View solution

Q. Couple roof is used for spans

View solution

Q. If the depth of an excavation is 20 metres, number of single stage well points to be installed at various levels, is

View solution

Q. The minimum distance between the centres of bulb of diameter du, of a multi under reamed piles, is

View solution

Q. The method of moving each brick through a small horizontal distance before it is finally laid in any brick wall and pressing it by means of brick hammer, is known as

View solution

Q. The stone whose crushing strength is maximum, is

View solution

Q. The vertical member running through middle of a shutter frame, is

View solution

Q. In grillage foundations, distance between flanges of grillage beams, is kept

View solution

Q. Herringbone bond is used for

View solution

Q. A cut in frame of a door to receive the shutter, is called

View solution

Q. The alignment of a cross joint along the plumb line is

View solution

Q. A temporary rigid structure having platforms to enable masons to work at different stages of a building, is known as

View solution

Q. Pick up the incorrect statement from the following :

View solution

Q. For plastering the exposed brick walls, the cement sand mortar should be

View solution

Q. The construction joints in buildings are provided after

View solution

Q. The arrangement made to support an unsafe structure temporarily, is known as

View solution

Q. Pick up the correct statement from the following :

View solution

Q. The type of pointing in which upper side of mortar joints is kept about 12 mm inside the face of the masonry and bottom is kept flushed with face of wall, is

View solution

Q. The steel pile which is generally sunk in soft clay or loose sand of low bearing capacity, is

View solution