Q. The type of pointing in which upper side of mortar joints is kept about 12 mm inside the face of the masonry and bottom is kept flushed with face of wall, is

View solution

Q. The steel pile which is generally sunk in soft clay or loose sand of low bearing capacity, is

View solution

Q. The stepped structure provided for lateral support of a structure, is

View solution

Q. In the method of tube boring of soil investigation, the following is essential :

View solution

Q. For each storey of a building, the depth of exploration should be

View solution

Q. Safe bearing capacity of black cotton soil varies from

View solution

Q. Crown is located at

View solution

Q. The nominal thickness of an expansion joint in brick walls, is kept more than

View solution

Q. The nominal thickness of one brick wall in mm, is

View solution

Q. The pile which supports the load partly by friction and partly by resting on hard stratum, is called

View solution

Q. To stagger vertical joints in successive courses of a wall, a piece of brick is generally used at the end of the course, which is known as

View solution

Q. The concrete slump recommended for foundations, is

View solution

Q. The minimum thickness of walls built in cement mortar (1 : 6) for a single storey building, is

View solution

Q. The form work from the slabs excluding props, can be removed only after

View solution

Q. The pile provided with one or more bulles in its vertical shaft, is generally known as

View solution

Q. To construct a 10 cm thick partition wall, you will prefer

View solution

Q. The pile which supports the load due to friction between pile face and surrounding soil, is generally known as

View solution

Q. The voussoir placed at crown of an arch, is known as a

View solution

Q. The vertical members fixed between steps and hand rail, are known

View solution

Q. Pick up the consideration to the taken while designing a hospital from the following :

View solution