Q. Allowable shear strength of concrete, depends upon

View solution

Q. The most useless aggregate is one whose surface texture is

View solution

Q. To obtain a very high strength concrete, use very fine grained

View solution

Q. For the construction of R.C.C. slabs, columns, beams, walls, etc. the grade of concrete mix used, is

View solution

Q. The type of aggregates of same nominal size, which contain less voids when compacted, are

View solution

Q. For the construction of cement con-certe dams, the maximum permissible size of the aggregates, is

View solution

Q. Permissible compressive strength of M 200 concrete grade is

View solution

Q. For preparing a test-specimen, it is necessary

View solution

Q. Concrete containing

View solution

Q. An ordinary Portland cement when tested for its fineness, should not leave any residue on I.S. seive No. 9, more than

View solution

Q. The top diameter, bottom diameter and the height of a slump mould are :

View solution

Q. Workability of concrete mix with low water cement ratio is determined by

View solution

Q. While designing an air entrained concrete

View solution

Q. Ordinary Portland cement is manufactured from

View solution

Q. A flaky aggregate is said to be elongated if its length is

View solution

Q. To prevent segregation, the maximum height for placing concrete, is

View solution

Q. If the various concrete ingredients i.e. cement, sand and aggregates are in the ratio of 1:3:6, the grade of concrete, is

View solution

Q. Water cement ratio is generally expressed in volume of water required per

View solution

Q. Pick up the incorrect statement from the following:

View solution

Q. In slump test, each layer of concrete is compacted by a steel rod 60 cm long and of 16 mm diameter for

View solution