Q. An arch with three hinges, is a structure

View solution

Q. Stress in members of statically determinate simple frames, can be determined by

View solution

Q. While testing a cast iron beam (2.5 cm x 2.5 cm) in section and a metre long simply supported at the ends failed when a 100 kg weight is applied at the centre. The maximum stress induced is :

View solution

Q. The tensile force required to cause an elongation of 0.045 mm in a steel rod of 1000 mm length and 12 mm diameter, is (where E = 2 x 10⁶ kg/cm²)

View solution

Q. According to Unwin's formula, the diameter d of a rivet of plate of thickness t is :

View solution

Q. In a bar of large length when held vertically and subjected to a load at its lower end, its own-weight produces additional stress. The maximum stress will be

View solution

Q. If a shaft is simultaneously subjected to a toque T and a bending moment M, the ratio of maximum bending stress and maximum shearing stress is

View solution

Q. Struts are load carrying members of a frame structure which are subjected to

View solution

Q. A simply supported wooden beam 150 cm long and having a cross section 16 cm x 24 cm carries a concentrated load, at the centre. If the permissible stress ft = 75 kg/cm² and fs = 10 kg/cm² the safe load is

View solution

Q. A solid cube is subjected to equal normal forces on all its faces. The volumetric strain will be x-times the linear strain in any of the three axes when

View solution

Q. When equal and opposite forces applied to a body, tend to elongate it, the stress so produced, is called

View solution

Q. Stress in a beam due to simple bending, is

View solution

Q. A cantilever carrying a uniformly distributed load W over its full length is propped at its free end such that it is at the level of the fixed end. The bending moment will be zero at its free end also at

View solution

Q. In rectangular columns (cross-section b x h), the core is a

View solution

Q. A simply supported beam of span L carries a uniformly distributed load W. The maximum bending moment M is

View solution

Q. A cantilever beam rectangular in cross-section is subjected to an isolated load at its free end. If the width of the beam is doubled, the deflection of the free end will be changed in the ratio of

View solution

Q. The phenomenon of slow extension of materials having constant load, i.e. increasing with the time is called

View solution

Q. n and j are numbers of members and joints in a frame. It contains redundant members if

View solution

Q. The materials which have the same elastic properties in all directions, are called

View solution

Q. In a three hinged arch, the third hinge is generally kept at

View solution