Q. A cantilever carrying a uniformly distributed load W over its full length is propped at its free end such that it is at the level of the fixed end. The bending moment will be zero at its free end also at

View solution

Q. In rectangular columns (cross-section b x h), the core is a

View solution

Q. A simply supported beam of span L carries a uniformly distributed load W. The maximum bending moment M is

View solution

Q. A cantilever beam rectangular in cross-section is subjected to an isolated load at its free end. If the width of the beam is doubled, the deflection of the free end will be changed in the ratio of

View solution

Q. The phenomenon of slow extension of materials having constant load, i.e. increasing with the time is called

View solution

Q. n and j are numbers of members and joints in a frame. It contains redundant members if

View solution

Q. The materials which have the same elastic properties in all directions, are called

View solution

Q. In a three hinged arch, the third hinge is generally kept at

View solution

Q. A bending moment may be defined as :

View solution

Q. The length of a column, having a uniform circular cross-section of 7.5 cm diameter and whose ends are hinged, is 5 m. If the value of E for the material is 2100 tonnes/cm², the permissible maximum crippling load will be

View solution

Q. If a three hinged parabolic arch carries a uniformly distributed load on its entire span, every section of the arch resists.

View solution

Q. In a three hinged arch, the shear force is usually

View solution

Q. An arch may be subjected to

View solution

Q. The law which states, "within elastic limits strain produced is proportional to the stress producing it", is known as

View solution

Q. The maximum resistance against rotation, is offered by the weld at a point

View solution

Q. For structural analysis of forces, the method refers to

View solution

Q. The reaction at the supports will be vertical to the plane of the support if the frame structure rests on

View solution

Q. The property of a material by which it can be beaten or rolled into thin plates, is called

View solution

Q. If a constant section beam is subjected to a uniform bending moment throughout, its length bends to

View solution

Q. A simply supported beam (l + 2a) with equal overhangs (a) carries a uniformly distributed load over the whole length, the B.M. changes sign if

View solution