Q. If a constant section beam is subjected to a uniform bending moment throughout, its length bends to

View solution

Q. A simply supported beam (l + 2a) with equal overhangs (a) carries a uniformly distributed load over the whole length, the B.M. changes sign if

View solution

Q. The type of butt joints in common use, is :

View solution

Q. For structural analysis, Maxwell's reciprocal theorem can be applied to :

View solution

Q. The shape of the bending moment diagram over the length of a beam, carrying a uniformly increasing load, is always

View solution

Q. When a rectangular beam is loaded longitudinally, shear develops on

View solution

Q. The tension coefficient of any member is

View solution

Q. A steel rod of 2 cm diameter and 5 metres long is subjected to an axial pull of 3000 kg. If E = 2.1 x 10⁶, the elongation of the rod will be

View solution

Q. If the stress in each cross-section of a pillar is equal to its working stress, it is called

View solution

Q. The stress at which extension of a material takes place more quickly as compared to the increase in load, is called

View solution

Q. In a square beam loaded longitudinally, shear develops

View solution

Q. In a three hinged arch, the bending moment will be zero

View solution

Q. The ratio of the tensile stress developed in the wall of a boiler in the circumferential direction to the tensile stress in the axial direction, is

View solution

Q. In a shaft shear stress intensity at a point is not

View solution

Q. Along the neutral axis of a simply supported beam

View solution

Q. A joint of a frame is subjected to three tensile force P, Q and R equally inclined to each other. If P is 10 tonnes, the other forces will be

View solution

Q. A simply supported beam carries two equal concentrated loads W at distances L/3 from either support. The maximum bending moment

View solution

Q. Pick up the correct statement from the following :

View solution

Q. For a simply supported beam carrying uniformly distributed load W on it entire length L, the maximum bending moment is

View solution

Q. The shiftness factor for a prismatic beam of length L and moment of inertia I, is

View solution