Q. The tension coefficient of any member is

View solution

Q. A steel rod of 2 cm diameter and 5 metres long is subjected to an axial pull of 3000 kg. If E = 2.1 x 10⁶, the elongation of the rod will be

View solution

Q. If the stress in each cross-section of a pillar is equal to its working stress, it is called

View solution

Q. The stress at which extension of a material takes place more quickly as compared to the increase in load, is called

View solution

Q. In a square beam loaded longitudinally, shear develops

View solution

Q. In a three hinged arch, the bending moment will be zero

View solution

Q. The ratio of the tensile stress developed in the wall of a boiler in the circumferential direction to the tensile stress in the axial direction, is

View solution

Q. In a shaft shear stress intensity at a point is not

View solution

Q. Along the neutral axis of a simply supported beam

View solution

Q. A joint of a frame is subjected to three tensile force P, Q and R equally inclined to each other. If P is 10 tonnes, the other forces will be

View solution

Q. A simply supported beam carries two equal concentrated loads W at distances L/3 from either support. The maximum bending moment

View solution

Q. Pick up the correct statement from the following :

View solution

Q. For a simply supported beam carrying uniformly distributed load W on it entire length L, the maximum bending moment is

View solution

Q. The shiftness factor for a prismatic beam of length L and moment of inertia I, is

View solution

Q. The stress in the wall of a cylinder in a direction normal to its longitudinal axis, due to a force acting along the circumference, is known as

View solution

Q. In a simply supported beam (l + 2a) with equal overhangs (a) and carrying a uniformly distributed load over its entire length, B.M. at the middle point of the beam will be zero if

View solution

Q. Along the principal plan subjected to maximum principal stress

View solution

Q. A diagram which shows the variations of the axial load for all sections of the span of a beam, is called

View solution

Q. A member which does not regain its original shape after removed of load producing deformation is said

View solution

Q. The point of contraflexture occurs in

View solution