Q. In a simply supported beam (l + 2a) with equal overhangs (a) and carrying a uniformly distributed load over its entire length, B.M. at the middle point of the beam will be zero if

View solution

Q. Along the principal plan subjected to maximum principal stress

View solution

Q. A diagram which shows the variations of the axial load for all sections of the span of a beam, is called

View solution

Q. A member which does not regain its original shape after removed of load producing deformation is said

View solution

Q. The point of contraflexture occurs in

View solution

Q. A member which is subjected to reversible tensile or compressive stress may fail at a stress lower than the ultimate stress of the material. This property of metal, is called

View solution

Q. If the width b and depth d of a beam simply supported with a central load are interchanged, the deflection at the centre of the beam will be changed in the ratio of

View solution

Q. The maximum stress intensity due to a suddenly applied load is x-times the stress intensity produced by the load of the same magnitude applied gradually. The value of x is

View solution

Q. Strain energy of a member may be equated to

View solution

Q. At either end of a plane frame, maximum number of possible bending moments, are

View solution

Q. The principal stresses at a point are 100, 100 and-200 kgf/cm², the octo hedral shear stress at the point is :

View solution

Q. During a tensile test on a ductile material

View solution

Q. Rankine-Golden formula accounts for direct as well as buckling stress and is applicable to

View solution

Q. Pick up the correct statement from the following :

View solution

Q. The moment diagram for a cantilever carrying a concentrated load at its free end, will be

View solution

Q. In a shaft rotated by a couple, the shear force varies

View solution

Q. The section modulus of a rectangular light beam 25 metres long is 12.500 cm³. The beam is simply supported at its ends and carries a longitudinal axial tensile load of 10 tonnes in addition to a point load of 4 tonnes at the centre. The maximum stress in the bottom most fibre at the mid span section, is

View solution

Q. The ratio of the maximum deflection of a cantilever beam with an isolated load at its free end and with a uniformly distributed load over its entire length, is

View solution

Q. For a beam of uniform strength keeping its depth constant, the width will vary in proportion to

View solution

Q. A shaft 9 m long is subjected to a torque 30 t-m at a point 3 m distant from either end. The reactive torque at the nearer end will be

View solution