Q. Along the principal plan subjected to maximum principal stress

View solution

Q. A diagram which shows the variations of the axial load for all sections of the span of a beam, is called

View solution

Q. A member which does not regain its original shape after removed of load producing deformation is said

View solution

Q. The point of contraflexture occurs in

View solution

Q. A member which is subjected to reversible tensile or compressive stress may fail at a stress lower than the ultimate stress of the material. This property of metal, is called

View solution

Q. If the width b and depth d of a beam simply supported with a central load are interchanged, the deflection at the centre of the beam will be changed in the ratio of

View solution

Q. The maximum stress intensity due to a suddenly applied load is x-times the stress intensity produced by the load of the same magnitude applied gradually. The value of x is

View solution

Q. Strain energy of a member may be equated to

View solution

Q. At either end of a plane frame, maximum number of possible bending moments, are

View solution

Q. The principal stresses at a point are 100, 100 and-200 kgf/cm², the octo hedral shear stress at the point is :

View solution

Q. During a tensile test on a ductile material

View solution

Q. Rankine-Golden formula accounts for direct as well as buckling stress and is applicable to

View solution

Q. Pick up the correct statement from the following :

View solution

Q. The moment diagram for a cantilever carrying a concentrated load at its free end, will be

View solution

Q. In a shaft rotated by a couple, the shear force varies

View solution

Q. The section modulus of a rectangular light beam 25 metres long is 12.500 cm³. The beam is simply supported at its ends and carries a longitudinal axial tensile load of 10 tonnes in addition to a point load of 4 tonnes at the centre. The maximum stress in the bottom most fibre at the mid span section, is

View solution

Q. The ratio of the maximum deflection of a cantilever beam with an isolated load at its free end and with a uniformly distributed load over its entire length, is

View solution

Q. For a beam of uniform strength keeping its depth constant, the width will vary in proportion to

View solution

Q. A shaft 9 m long is subjected to a torque 30 t-m at a point 3 m distant from either end. The reactive torque at the nearer end will be

View solution

Q. The width b and depth d of a beam cut from a wooden cylindrical log of 100 cm diameter for maximum strength are :

View solution