Q. If the stress produced by a prismatic bar is equal to the working stress, the area of the cross-section of the prismatic bar, becomes

View solution

Q. For keeping the stress wholly compressive the load may be applied on a circular column anywhere within a concentric circle of diameter

View solution

Q. A member is balanced at its end by two inclined members carrying equal forces. For equilibrium the angle between the inclined bars must be

View solution

Q. To ascertain the maximum permissible eccentricity of loads on circular columns, the rule generally followed, is

View solution

Q. If a steel rod of 20 mm diameter and 5 metres long elongates by 2.275 mm when subjected to an axial pull of 3000 kg, the stress developed, is

View solution

Q. Shear force for a cantilever carrying a uniformly distributed load over its length, is

View solution

Q. If the width of a simply supported beam carrying an isolated load at its centre is doubled, the deflection of the beam at the centre is changed by

View solution

Q. For a stable frame structure, number of members required, is

View solution

Q. When a rectangular beam is loaded transversely, the maximum compressive stress develops on

View solution

Q. The under mentioned type is simple strain

View solution

Q. The ratio of the effective length of a column and minimum radius of gyration of its cross-sectional area, is known

View solution

Q. Failure of riverted joints is due to

View solution

Q. The maximum load to which a fillet joint of length L can be subjected to, is

View solution

Q. Beams of uniform strength are preferred to those of uniform section because these are economical for

View solution

Q. The moment diagram for a cantilever whose free end is subjected to a bending moment, will be a

View solution

Q. Reactions at the supports of a structure can be determined by equating the algebraic sum of

View solution

Q. The bending moment is maximum on a section where shearing force

View solution

Q. Pick up the correct statement from the following :

View solution

Q. A short masonry pillar is 60 cm x 60 cm in cross-section, the core of the pillar is a square whose side is

View solution

Q. A rectangular log of wood is floating in water with a load of 100 N at its centre. The maximum shear force in the wooden log is

View solution