Q. In a shaft rotated by a couple, the shear force varies

View solution

Q. The section modulus of a rectangular light beam 25 metres long is 12.500 cm³. The beam is simply supported at its ends and carries a longitudinal axial tensile load of 10 tonnes in addition to a point load of 4 tonnes at the centre. The maximum stress in the bottom most fibre at the mid span section, is

View solution

Q. The ratio of the maximum deflection of a cantilever beam with an isolated load at its free end and with a uniformly distributed load over its entire length, is

View solution

Q. For a beam of uniform strength keeping its depth constant, the width will vary in proportion to

View solution

Q. A shaft 9 m long is subjected to a torque 30 t-m at a point 3 m distant from either end. The reactive torque at the nearer end will be

View solution

Q. The width b and depth d of a beam cut from a wooden cylindrical log of 100 cm diameter for maximum strength are :

View solution

Q. If the stress produced by a prismatic bar is equal to the working stress, the area of the cross-section of the prismatic bar, becomes

View solution

Q. For keeping the stress wholly compressive the load may be applied on a circular column anywhere within a concentric circle of diameter

View solution

Q. A member is balanced at its end by two inclined members carrying equal forces. For equilibrium the angle between the inclined bars must be

View solution

Q. To ascertain the maximum permissible eccentricity of loads on circular columns, the rule generally followed, is

View solution

Q. If a steel rod of 20 mm diameter and 5 metres long elongates by 2.275 mm when subjected to an axial pull of 3000 kg, the stress developed, is

View solution

Q. Shear force for a cantilever carrying a uniformly distributed load over its length, is

View solution

Q. If the width of a simply supported beam carrying an isolated load at its centre is doubled, the deflection of the beam at the centre is changed by

View solution

Q. For a stable frame structure, number of members required, is

View solution

Q. When a rectangular beam is loaded transversely, the maximum compressive stress develops on

View solution

Q. The under mentioned type is simple strain

View solution

Q. The ratio of the effective length of a column and minimum radius of gyration of its cross-sectional area, is known

View solution

Q. Failure of riverted joints is due to

View solution

Q. The maximum load to which a fillet joint of length L can be subjected to, is

View solution

Q. Beams of uniform strength are preferred to those of uniform section because these are economical for

View solution