Q. In a three hinged arch, the bending moment will be zero

View solution

Q. The ratio of the tensile stress developed in the wall of a boiler in the circumferential direction to the tensile stress in the axial direction, is

View solution

Q. In a shaft shear stress intensity at a point is not

View solution

Q. Along the neutral axis of a simply supported beam

View solution

Q. A joint of a frame is subjected to three tensile force P, Q and R equally inclined to each other. If P is 10 tonnes, the other forces will be

View solution

Q. A simply supported beam carries two equal concentrated loads W at distances L/3 from either support. The maximum bending moment

View solution

Q. Pick up the correct statement from the following :

View solution

Q. For a simply supported beam carrying uniformly distributed load W on it entire length L, the maximum bending moment is

View solution

Q. The shiftness factor for a prismatic beam of length L and moment of inertia I, is

View solution

Q. The stress in the wall of a cylinder in a direction normal to its longitudinal axis, due to a force acting along the circumference, is known as

View solution

Q. In a simply supported beam (l + 2a) with equal overhangs (a) and carrying a uniformly distributed load over its entire length, B.M. at the middle point of the beam will be zero if

View solution

Q. Along the principal plan subjected to maximum principal stress

View solution

Q. A diagram which shows the variations of the axial load for all sections of the span of a beam, is called

View solution

Q. A member which does not regain its original shape after removed of load producing deformation is said

View solution

Q. The point of contraflexture occurs in

View solution

Q. A member which is subjected to reversible tensile or compressive stress may fail at a stress lower than the ultimate stress of the material. This property of metal, is called

View solution

Q. If the width b and depth d of a beam simply supported with a central load are interchanged, the deflection at the centre of the beam will be changed in the ratio of

View solution

Q. The maximum stress intensity due to a suddenly applied load is x-times the stress intensity produced by the load of the same magnitude applied gradually. The value of x is

View solution

Q. Strain energy of a member may be equated to

View solution

Q. At either end of a plane frame, maximum number of possible bending moments, are

View solution