Q. If all the dimensions of a bar are increased in the proportion n : 1, the proportion with which the maximum stress produced in the prismatic bar by its own weight, will increase in the ratio

View solution

Q. The slenderness ratio of a vertical column of square cross- section of 10 cm side and 500 cm long, is

View solution

Q. The cross sections of the beams of equal length are a circle and a square whose permissible bending stress are same under same maximum bending. The ratio of their flexural weights is,

View solution

Q. When two plates butt together and are riveted with two cover plates with two rows of rivets, the joint is known as

View solution

Q. The moment diagram for a cantilever which is subjected to a uniformly distributed load will be a

View solution

Q. The areas of cross-section of a square beam and a circular beam subjected to equal bending moments, are same.

View solution

Q. For the same height, the bottom width for no tension,

View solution

Q. The intensity of direct longitudinal stress in the cross-section at any point distant r from the neutral axis, is proportional to

View solution

Q. For a beam, if fundamental equations of statics are not sufficient to determine all the reactive forces at the supports, the structure is said to be

View solution

Q. The moment diagram for a cantilever carrying linearly varying load from zero at its free end and to maximum at the fixed end will be a

View solution

Q. The effect of arching a beam, is

View solution

Q. The phenomenon of slow growth of strain under a steady tensile stress, is called

View solution

Q. Hooke's law states that stress and strain are

View solution

Q. A 8 metre long simply supported rectangular beam which carries a distributed load 45 kg/m. experiences a maximum fibre stress 160 kg/cm². If the moment of inertia of the beam is 640 cm⁴, the overall depth of the beam is

View solution

Q. If the depth of a simply supported beam carrying an isolated load at its centre, is doubled, the deflection of the beam at the centre will be changed by a factor of

View solution

Q. The equivalent length of a column fixed at one end and free at the other end, is

View solution

Q. A cast iron T section beam is subjected to pure bending. For maximum compressive stress to be three times the maximum tensile stress, centre of gravity of the section from flange side is

View solution

Q. The equivalent length of a column fixed at both ends, is

View solution

Q. The rise of a parabolic arch at quarter points, is equal to

View solution