Question
a.
75 mm
b.
77 mm
c.
79 mm
d.
81 mm.
Posted under Civil Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The respective storm totals at three surrounding stations A, B and C are 110, 90 and 70 mm. If the normal annual precipitation amounts at stations X, A, B and C are respectively...
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The recurrence interval (R.I.) of 20 cm rain storm at a place is 5 years.
View solution
Q. Sharp crested weirs are generally used
View solution
Q. The area of a drainage basin whose axial length is 100 km is 2500 sq. km. Its form factor is
View solution
Q. If the axial length of a drainage basin is 35 km and its form factor is 0.2, the total area of the basin is
View solution
Q. Run off is measured in
View solution
Q. For efficient working of a control meter, its throat length is approximately kept
View solution
Q. A control meter is preferred to a weir because
View solution
Q. A river is said to be of uniform section if in its section
View solution
Q. The run off is affected by
View solution
Q. The form factor of a drainage basin is obtained by dividing
View solution
Q. Isopiastic lines are the contours
View solution
Q. The coefficients of permeability of soils of an unconfined aquifer and another confined aquifer were determined by pumping water from the wells and observing the effect of water table in two test wells at equal distances was found to be equal. The total height of confined aquifer H is given by
View solution
Q. The radius of influence is
View solution
Q. When a constant discharge 2.91 litres/sec. was obtained in a pumping test, the draw downs in the test wells at 3 m and 6.184 m were 2.6 m and 0.3 m respectively. If over-all depth of the pumping well was 16 m, the permeability of the soil, is
View solution
Q. If h is the loss due to friction in a pipe. Total losses in strainer and bends may be taken as
View solution
Q. If the loss due to friction in pipes is 4 m, the total losses in strainer and bends may be taken as
View solution
Q. The rate of evaporation from reservoirs may be determined by
View solution
Q. In estimating the rate of evaporation from the reservoir surface, a pan 1.5 metres in diameter, was filled upto 8.0 cm. During a specified period of time, the rainfall recorded was 5 cm. 3 cm of water was removed from the pan to keep the depth of water. At the end of the time, the depth was 9 cm. If the pan coefficient is 0.6, the evaporation loss is
View solution
Q. Dicken's formula for high flood estimate, is useful only for the catchments in
View solution
Q. Relative humidity is the ratio of actual vapour pressure to the saturation vapour pressure
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!