Question

Humidity refers to

a.

temperature of the air

b.

pressure of the air

c.

moisture content of the air

d.

volume of the air.

Posted under Civil Engineering

Answer: (c).moisture content of the air

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Humidity refers to

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. If the dew point is greater than 0°C

Q. A volume of air at constant barometric pressure may be brought to dew point by

Q. Pressure exerted by fully saturated air, is known

Q. Pick up the correct statement from the following :

Q. The equation P - Q = Te φindex for determining the infiltration capacity, was suggested by

Q. If the slope of a line for infiltration capacity curve is 1/1.737 , the value of constant k in Horton's equation of infiltration capacity curve, is

Q. Pick up the correct statement from the following :

Q. A soil strata may consist of

Q. Pick up the correct statement from the following :

Q. The specifications of most commonly used standard gauges in India, are

Q. Precipitation caused due to striking of air masses with a topographical feature, is called

Q. Precipitation caused due to upward movement of warmer air as compared to surrounding air, is called

Q. Pick up correct statement from the following :

Q. Relative humidity is the ratio of actual vapour pressure to the saturation vapour pressure

Q. Dicken's formula for high flood estimate, is useful only for the catchments in

Q. In estimating the rate of evaporation from the reservoir surface, a pan 1.5 metres in diameter, was filled upto 8.0 cm. During a specified period of time, the rainfall recorded was 5 cm. 3 cm of water was removed from the pan to keep the depth of water. At the end of the time, the depth was 9 cm. If the pan coefficient is 0.6, the evaporation loss is

Q. The rate of evaporation from reservoirs may be determined by

Q. If the loss due to friction in pipes is 4 m, the total losses in strainer and bends may be taken as

Q. If h is the loss due to friction in a pipe. Total losses in strainer and bends may be taken as

Q. When a constant discharge 2.91 litres/sec. was obtained in a pumping test, the draw downs in the test wells at 3 m and 6.184 m were 2.6 m and 0.3 m respectively. If over-all depth of the pumping well was 16 m, the permeability of the soil, is

Recommended Subjects

Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!