Q. The thickness t of a single flat lacing should not be less than

View solution

Q. For the steel member exposed to weather and accessible for repainting, the thickness of steel should not be less than (excepting the webs of Indian Standard rolled steel joists and channels).

View solution

Q. Live load

View solution

Q. The most economical section for a column, is

View solution

Q. If the depth of two column sections are equal, then the column splice is provided

View solution

Q. The distance between e.g. of compression and e.g. of tension flanges of a plate girder, is known as

View solution

Q. The effective length of a compression member of length L held in position and restrained in direction at one end and effectively restrained in direction but not held in position at the other end, is

View solution

Q. The ratio of shearing stress to shearing strain within elastic limit, is known as

View solution

Q. For determination of allowable stress in axial compression, Indian Standard Institution has adopted

View solution

Q. The method of design of steel framework for greatest rigidity and economy in weight, is known as

View solution

Q. If the pitch is 6 cm and rivet value is 4 tonnes, the number of rivets required for a riveted connection carrying an eccentric load of 15 tonnes at a distance of 30 cm from the centre line, is

View solution

Q. Pick up the correct statement from the following:

View solution

Q. A structural member subjected to compressive stress in a direction parallel to its longitudinal axis, is generally known as

View solution

Q. The minimum edge distance of a rivet line connecting two or more plates, is kept equal to 37 mm plus (where t is the thickness in mm of the thinner outside plate).

View solution

Q. Pick up the correct statement from the following:

View solution

Q. The maximum permissible slenderness ratio of a member carrying loads resulting from wind, is

View solution

Q. If d is the distance between the flange angles, the vertical stiffeners in plate girders are spaced not greater than

View solution

Q. If the unsupported length of a stanchion is 4 metres and least radius of gyration of its cross-section is 5, the slenderness ratio of the stanchion, is

View solution

Q. In plastic analysis, the shape factor for circular sections, is

View solution

Q. A beam is defined as a structural member subjected to

View solution