Q. Pick up the correct statement from the following:

View solution

Q. A structural member subjected to compressive stress in a direction parallel to its longitudinal axis, is generally known as

View solution

Q. The minimum edge distance of a rivet line connecting two or more plates, is kept equal to 37 mm plus (where t is the thickness in mm of the thinner outside plate).

View solution

Q. Pick up the correct statement from the following:

View solution

Q. The maximum permissible slenderness ratio of a member carrying loads resulting from wind, is

View solution

Q. If d is the distance between the flange angles, the vertical stiffeners in plate girders are spaced not greater than

View solution

Q. If the unsupported length of a stanchion is 4 metres and least radius of gyration of its cross-section is 5, the slenderness ratio of the stanchion, is

View solution

Q. In plastic analysis, the shape factor for circular sections, is

View solution

Q. A beam is defined as a structural member subjected to

View solution

Q. According to IS : 800 - 71, the minimum thickness of a vertically stiffened web plate, shall not be less than

View solution

Q. A fillet weld may be termed as

View solution

Q. When a load is transferred through one surface to another surface in contact, the stress is known as

View solution

Q. The most commonly used sections in lateral system to carry shear force in built up columns, are

View solution

Q. For steel members not exposed to weather, the thickness of steel should not be less than

View solution

Q. The minimum pitch of rivet holes of diameter d should not be less than

View solution

Q. The effective length of a weld, is taken as the actual length

View solution

Q. The permissible bearing stress in steel, is

View solution

Q. The main assumption of the method of simple design of steel frame work, is :

View solution

Q. A 20 mm dia steel bar which is subjected to an axial tension of 2300 kg/cm² produces a strain of 0.004 cm. If Young's modulus of steel is 2.1 x 10⁶ kg/cm², the bar is

View solution

Q. Poisson's ratio for steel within elastic limit, ranges from

View solution