Q. The main assumption of the method of simple design of steel frame work, is :

View solution

Q. A 20 mm dia steel bar which is subjected to an axial tension of 2300 kg/cm² produces a strain of 0.004 cm. If Young's modulus of steel is 2.1 x 10⁶ kg/cm², the bar is

View solution

Q. Poisson's ratio for steel within elastic limit, ranges from

View solution

Q. When a large value of radius of gyration is not required

View solution

Q. The maximum axial load which is just sufficient to keep a column in a small deflected shape, is called

View solution

Q. If the slenderness ratio is greater than 160, the allowable stress in axial compression is multiplied by a factor (1.2 - (l/xy) where x is

View solution

Q. The effective length of a compression member of length L, held in position and restrained in direction at both ends, is

View solution

Q. Spans of continuous fillers are considered approximately equal if the longest span does not exceed the shortest span by more than

View solution

Q. The gross diameter of a rivet is the diameter of

View solution

Q. The effective length L of a simply supported beam with ends restrained against torsion, and also the ends of compression flange partially restrained against lateral bending, is given by

View solution

Q. Rolled steel beams are designated by Indian Standard series and its

View solution

Q. The spans are considered approximately equal if the longest span does not exceed the shortest span by more than

View solution

Q. If the depth of the section of an upper column is smaller than the lower column

View solution

Q. A tension member, if subjected to possible reversal of stress due to wind, the slenderness ratio of the member should not exceed

View solution

Q. The rivets which are heated and then driven in the field, are known

View solution

Q. The strength of a riveted lap joint is equal to its

View solution

Q. The slenderness ratio of a column is zero when its length

View solution

Q. The main advantage of a steel member, is :

View solution

Q. The beams supporting the steps of a stair are generally known as

View solution

Q. For a steel grillage footing to support two unequal column loads

View solution