Q. The strength of a riveted lap joint is equal to its

View solution

Q. The slenderness ratio of a column is zero when its length

View solution

Q. The main advantage of a steel member, is :

View solution

Q. The beams supporting the steps of a stair are generally known as

View solution

Q. For a steel grillage footing to support two unequal column loads

View solution

Q. In case of cantilever fillers, the ratio of the span L to depth d, should not exceed

View solution

Q. Strengths of a rivet in single shearing, in bearing and in tearing are 3425 kg, 4575 kg and 5025 kg respectively. If the load in the member is 35 tonnes, the number of rivets required, is

View solution

Q. In a fillet weld placed on the sides of the base, the metal experiences

View solution

Q. The bending moment for filler joists at the middle of at intermediate span, is

View solution

Q. The Indian standard code which deals with steel structures, is

View solution

Q. When two plates are placed end to end and are joined by two cover plates, the joint is known as

View solution

Q. A compression member consisting of angle sections may be a

View solution

Q. According to IS : 800-1962 the permissible bending stress in steel slab plates, is

View solution

Q. A simply supported beam carrying a central load, will be safe in deflection if the ratio of its span to depth, is

View solution

Q. For double angles carrying tension, placed back to back and connected to either side of the gusset plate, the sectional area of the section, is equal to cross sectional area of

View solution

Q. The moment of the couple set up in a section of a beam by the logitudinal compressive and tensile force, is known as

View solution

Q. Pick up the correct statement from the following:

View solution

Q. A major beam in a building structure, is known as

View solution

Q. Rolled steel Tee-sections are used

View solution

Q. When the length of a tension member is too long

View solution