Q. Pick up the correct statement from the following:

View solution

Q. A major beam in a building structure, is known as

View solution

Q. Rolled steel Tee-sections are used

View solution

Q. When the length of a tension member is too long

View solution

Q. An imaginary line along which rivets are placed, is known as

View solution

Q. The allowable stress in axial tension is generally kept less if thickness of the member is more than

View solution

Q. The maximum permissible slenderness ratio of compression member carrying dead and superimposed load, is

View solution

Q. The safe working pressure for a spherical vessel 1.5 m diameter and having 1.5 cm thick wall not to exceed tensile stress 50kg/cm² , is

View solution

Q. Diameter of a rivet hole is made larger than the diameter of the rivet by

View solution

Q. When a tension member consists of two channel sections, the allowance for rivet hole is made for two holes from

View solution

Q. If d is the distance between the flange angles, the vertical stiffeners in plate girders without horizontal stiffeners, are spaced at a distance not less than

View solution

Q. A column splice is used to increase

View solution

Q. To the calculated area of cover plates of a built-up beam, an allowance for rivet holes to be added, is

View solution

Q. The connection of one beam to another beam by means of an angle at the bottom and an angle at the top, is known as

View solution

Q. Allowable working stress corresponding to the slenderness ratio of double angles placed back to back and connected to one side of a gusset plate, is reduced to

View solution

Q. Bulb angles are used in

View solution

Q. Effective sectional area of a compression member is :

View solution

Q. A fillet weld whose axis is parallel to the direction of the applied load, is known as

View solution

Q. Assuming the values of maximum deviation ΔP and ΔE to be 25% of the computed value of P and E respectively, the minimum value of the factor of safety is

View solution

Q. In case horizontal stiffeners are not used, the distance between vertical legs of flange angles at the top and bottom of a plate girder, is known as

View solution