Q. The connection of one beam to another beam by means of an angle at the bottom and an angle at the top, is known as

View solution

Q. Allowable working stress corresponding to the slenderness ratio of double angles placed back to back and connected to one side of a gusset plate, is reduced to

View solution

Q. Bulb angles are used in

View solution

Q. Effective sectional area of a compression member is :

View solution

Q. A fillet weld whose axis is parallel to the direction of the applied load, is known as

View solution

Q. Assuming the values of maximum deviation ΔP and ΔE to be 25% of the computed value of P and E respectively, the minimum value of the factor of safety is

View solution

Q. In case horizontal stiffeners are not used, the distance between vertical legs of flange angles at the top and bottom of a plate girder, is known as

View solution

Q. Rolled steel angle sections are classified as

View solution

Q. Factor of safety is the ratio of

View solution

Q. If W and L are the total superimposed load and the span of a plate girder in metres, the approximate self weight (W) of the girder, is taken as

View solution

Q. The ratio of the span L of the filler joists to the depth d from the under side of the joist to the top of the structural concrete, should not exceed

View solution

Q. The maximum tensile and compressive bending stress in extreme fibres of rolled I-sections and channels on the effective section, is

View solution

Q. Perforated cover plates are particularly suitable for built up sections consisting of

View solution

Q. On eccentrically loaded columns, the equivalent axial load may be obtained by

View solution

Q. The distance between the outer faces of flanges of a plate girder, is known as

View solution

Q. Tacking rivets in compression plates not exposed to the weather, have a pitch not exceeding 300 mm or

View solution

Q. Effective length of a column effectively held in position and restrained in direction at one end but neither held in position nor restrained in direction at the other end, is

View solution

Q. The effective length of a double angle strut with angles placed back to back and connected to both the sides of a gusset plate, by not less than two rivets, is

View solution

Q. To keep the intensity of bearing pressure between the column base and concrete, compressive throughout the length of the column base, the ratio of the moment M to axial load P should be

View solution

Q. When the upper column does not provide full bearing area over lower column, the column splice is provided with the following assumption

View solution