Q. The maximum tensile and compressive bending stress in extreme fibres of rolled I-sections and channels on the effective section, is

View solution

Q. Perforated cover plates are particularly suitable for built up sections consisting of

View solution

Q. On eccentrically loaded columns, the equivalent axial load may be obtained by

View solution

Q. The distance between the outer faces of flanges of a plate girder, is known as

View solution

Q. Tacking rivets in compression plates not exposed to the weather, have a pitch not exceeding 300 mm or

View solution

Q. Effective length of a column effectively held in position and restrained in direction at one end but neither held in position nor restrained in direction at the other end, is

View solution

Q. The effective length of a double angle strut with angles placed back to back and connected to both the sides of a gusset plate, by not less than two rivets, is

View solution

Q. To keep the intensity of bearing pressure between the column base and concrete, compressive throughout the length of the column base, the ratio of the moment M to axial load P should be

View solution

Q. When the upper column does not provide full bearing area over lower column, the column splice is provided with the following assumption

View solution

Q. For a steel member of slenderness ratio 350, the allowable stress is 76 kg/cm² if it is

View solution

Q. The permissible stress to which a structural member can be subjected to, is known as

View solution

Q. Lug angle is

View solution

Q. Effective length of a column effectively held in position and restrained in direction at both ends, is

View solution

Q. A riveted joint many experience

View solution

Q. IS : 800 - 1971 recommends that in a splice plate the number of rivets carrying calculated shear stress through a packing greater than 6 mm thick, is to be increased by 2.5% for every

View solution

Q. The tensile strength of mild steel for bolts and nuts should not be less than

View solution

Q. A riveted joint may experience

View solution

Q. With a percentage increase of carbon in steel, decreases its

View solution

Q. In double lacing, the thickness t of flat lacing is

View solution

Q. The gross section of the web of a beam is defined as

View solution