Question
a.
tearing failure of plates
b.
bearing failure of plates
c.
splitting failure of plates at the edges
d.
all the above.
Posted under Civil Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A riveted joint many experience
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. IS : 800 - 1971 recommends that in a splice plate the number of rivets carrying calculated shear stress through a packing greater than 6 mm thick, is to be increased by 2.5% for every
View solution
Q. The tensile strength of mild steel for bolts and nuts should not be less than
View solution
Q. A riveted joint may experience
View solution
Q. With a percentage increase of carbon in steel, decreases its
View solution
Q. In double lacing, the thickness t of flat lacing is
View solution
Q. The gross section of the web of a beam is defined as
View solution
Q. For simply supported beams, the maximum permitted deflection, is
View solution
Q. In a truss girder of a bridge, a diagonal consists of mild steel flat 4001.S.F. and carries a pull of 80 tonnes. If the grossdiameter of the rivet is 26 mm, the number of rivets required in the splice, is
View solution
Q. Design of a riveted joint, is based on the assumption:
View solution
Q. The ratio of hydrostatic stress to the volumetric strain within the elastic range, is called
View solution
Q. The deflection of beams may be decreased by
View solution
Q. For a cantilever beam of length L built-in at the support and restrained against torsion at the free end, the effective projecting length l is
View solution
Q. In a built up section carrying a tensile force, the flanges of two channels are turned outward
View solution
Q. If P is the wind pressure in kg/cm², v is the velocity in km/hour and K is a constant of proportionality, then
View solution
Q. Length of an outstanding leg of a vertical stiffener, may be taken equal to
View solution
Q. Efficiency of a riveted joint is defined as the ratio of
View solution
Q. The stress in the wall of a thin cylinder subjected to internal pressure, is
View solution
Q. The diameter of a bolt hole is taken as the nominal diameter of the bolt plus
View solution
Q. Pick up the correct statement from the following:
View solution
Q. According to I.S. : 800 - 1871, lacing bars resist transverse shear equal to
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
