Question
a.
to simplify the transverse connections
b.
to minimise lacing
c.
to have greater lateral rigidity
d.
all the above
Posted under Civil Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In a built up section carrying a tensile force, the flanges of two channels are turned outward
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. If P is the wind pressure in kg/cm², v is the velocity in km/hour and K is a constant of proportionality, then
View solution
Q. Length of an outstanding leg of a vertical stiffener, may be taken equal to
View solution
Q. Efficiency of a riveted joint is defined as the ratio of
View solution
Q. The stress in the wall of a thin cylinder subjected to internal pressure, is
View solution
Q. The diameter of a bolt hole is taken as the nominal diameter of the bolt plus
View solution
Q. Pick up the correct statement from the following:
View solution
Q. According to I.S. : 800 - 1871, lacing bars resist transverse shear equal to
View solution
Q. The greatest permissible clear dimension of the web of thickness t in the panel of a plate girder, is restricted to
View solution
Q. As per ISI, rolled steel beam sections are classified into
View solution
Q. Water pressure in a 80 cm water main is 10 kg/cm². The minimum thickness of the metal required for the water main, not to be stressed more than 200 kg/cm², is
View solution
Q. In a tension member if one or more than one rivet holes are off the line, the failure of the member depends upon :
View solution
Q. The size of a butt weld is specified by the effective throat thickness which in the case of incomplete penetration, is taken as
View solution
Q. The thickness of the web of a mild steel plate girder is less than d/200. If only one horizontal stiffener is used, it is placed at
View solution
Q. The load on a lintel is assumed as uniformly distributed if the height of the masonry above it, is upto a height of
View solution
Q. Working shear stress on the gross area of a rivet as recommended by Indian Standards, is
View solution
Q. Pick up the correct statement from the following:
View solution
Q. Stiffeners are used in a plate girder
View solution
Q. The channels get twisted symmetrically with regard to its axis
View solution
Q. The stiff portion of a bearing stiffener is taken equal to
View solution
Q. Effective length of a column effectively held in position at both ends and restrained in direction at one end, is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
