Question

Stiffeners are used in a plate girder

a.

to reduce the compressive stress

b.

to reduce the shear stress

c.

to take the bearing stress

d.

to avoid bulking of web plate.

Posted under Civil Engineering

Answer: (d).to avoid bulking of web plate.

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Stiffeners are used in a plate girder

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The channels get twisted symmetrically with regard to its axis

Q. The stiff portion of a bearing stiffener is taken equal to

Q. Effective length of a column effectively held in position at both ends and restrained in direction at one end, is

Q. The strength of ISA 125 = 75 x 10 mm used as a tie member with its longer leg connected at the ends by 27 mm diameter rivets, is

Q. Cold driven rivets range from

Q. The main type of butt joints, is a double cover

Q. Outstanding length of a compression member consisting of a channel, is measured as

Q. The equivalent axial load may be defined as the load which produces a stress equal to

Q. If d is the distance between the flange angles of a plate girder, vertical stiffeners are provided at a distance not greater than

Q. The beam outside a wall upto floor level above it, is known as

Q. A structural member subjected to tensile force in a direction parallel to its logitudinal axis, is generally known as

Q. For the economical design of a combined footing to support two equal column loads, the projections of beams in lower tier are kept such that bending moment under column is equal to

Q. In rolled steel beams, shear force is mostly resisted by

Q. When plates are exposed to weather, tacking rivets are provided at a pitch in line not exceeding (where t is the thickness of the outside plate).

Q. The greatest gauge of long rivets should not exceed (where d is the diameter of the holes).

Q. Maximum permissible slenderness ratio of a member normally acting as a tie in a roof truss, is

Q. If d is the distance between the flange angles,

Q. The side thrust T on the tie rods provided at the end beam of jack arch of rise R, is calculated from the formula

Q. When the depth of a plate girder is at least n times the depth of vertical leg of the flange angles, the girder is known as deep plate girder, if n is

Q. Pick up the correct statement from the following:

Recommended Subjects

Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!