Q. The main type of butt joints, is a double cover

View solution

Q. Outstanding length of a compression member consisting of a channel, is measured as

View solution

Q. The equivalent axial load may be defined as the load which produces a stress equal to

View solution

Q. If d is the distance between the flange angles of a plate girder, vertical stiffeners are provided at a distance not greater than

View solution

Q. The beam outside a wall upto floor level above it, is known as

View solution

Q. A structural member subjected to tensile force in a direction parallel to its logitudinal axis, is generally known as

View solution

Q. For the economical design of a combined footing to support two equal column loads, the projections of beams in lower tier are kept such that bending moment under column is equal to

View solution

Q. In rolled steel beams, shear force is mostly resisted by

View solution

Q. When plates are exposed to weather, tacking rivets are provided at a pitch in line not exceeding (where t is the thickness of the outside plate).

View solution

Q. The greatest gauge of long rivets should not exceed (where d is the diameter of the holes).

View solution

Q. Maximum permissible slenderness ratio of a member normally acting as a tie in a roof truss, is

View solution

Q. If d is the distance between the flange angles,

View solution

Q. The side thrust T on the tie rods provided at the end beam of jack arch of rise R, is calculated from the formula

View solution

Q. When the depth of a plate girder is at least n times the depth of vertical leg of the flange angles, the girder is known as deep plate girder, if n is

View solution

Q. Pick up the correct statement from the following:

View solution

Q. Maximum permissible slenderness ratio of compression members which carry dead and superimposed load, is

View solution

Q. If the area of cross-section of a single angle discontinuous strut is 30 cm² and allowable working stress corresponding to its slenderness ratio is 625 kg/cm², the safe load carrying capacity of the member, is

View solution

Q. If N is the number of rivets in the joint, the strength of a riveted joint against shearing of rivets, is given by

View solution

Q. For steel members exposed to weather and not accessible for repainting, the thickness of steel should not be less than

View solution

Q. Compression members composed of two channels back-to-back and separated by a small distance are connected together by riveting so that the minimum slenderness ratio of each member between the connections, does not exceed

View solution