Question

For the economical design of a combined footing to support two equal column loads, the projections of beams in lower tier are kept such that bending moment under column is equal to

a.

bending moment at the centre of the beam

b.

half the bending moment at the centre of the beam

c.

twice the bending moment at the centre of the beam

d.

none of these.

Posted under Civil Engineering

Answer: (a).bending moment at the centre of the beam

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. For the economical design of a combined footing to support two equal column loads, the projections of beams in lower tier are kept such that bending moment under column is equal to

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. In rolled steel beams, shear force is mostly resisted by

Q. When plates are exposed to weather, tacking rivets are provided at a pitch in line not exceeding (where t is the thickness of the outside plate).

Q. The greatest gauge of long rivets should not exceed (where d is the diameter of the holes).

Q. Maximum permissible slenderness ratio of a member normally acting as a tie in a roof truss, is

Q. If d is the distance between the flange angles,

Q. The side thrust T on the tie rods provided at the end beam of jack arch of rise R, is calculated from the formula

Q. When the depth of a plate girder is at least n times the depth of vertical leg of the flange angles, the girder is known as deep plate girder, if n is

Q. Pick up the correct statement from the following:

Q. Maximum permissible slenderness ratio of compression members which carry dead and superimposed load, is

Q. If the area of cross-section of a single angle discontinuous strut is 30 cm² and allowable working stress corresponding to its slenderness ratio is 625 kg/cm², the safe load carrying capacity of the member, is

Q. If N is the number of rivets in the joint, the strength of a riveted joint against shearing of rivets, is given by

Q. For steel members exposed to weather and not accessible for repainting, the thickness of steel should not be less than

Q. Compression members composed of two channels back-to-back and separated by a small distance are connected together by riveting so that the minimum slenderness ratio of each member between the connections, does not exceed

Q. A beam may be designed as a cased beam if

Q. For a single section used as a tension member, the given area is assumed

Q. Long column is one

Q. Rolled steel beams are :

Q. Tacking rivets in tension members, are provided at a pitch in line not exceeding

Q. The effective length of a compression member of length L held in position at both ends but not restrained in direction, is

Q. If the thickness of a structural member is small as compared to its length and width, it is classified as

Recommended Subjects

Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!