Q. Tacking rivets in tension members, are provided at a pitch in line not exceeding

View solution

Q. The effective length of a compression member of length L held in position at both ends but not restrained in direction, is

View solution

Q. If the thickness of a structural member is small as compared to its length and width, it is classified as

View solution

Q. In factory buildings, the horizontal beams spanning between the wall columns supporting a wall covering, are called

View solution

Q. Pick up the correct statement from the following:

View solution

Q. Rise of a Jack arch is kept about

View solution

Q. The minimum width B of a solid casing for a cased beam, is equal to

View solution

Q. Design of a riveted joint is based on the assumption:

View solution

Q. A web plate is called unstiffened if the ratio of clear depth to thickness is less than

View solution

Q. Pick up the correct statement from the following:

View solution

Q. In a grillage footing, the maximum shear force occurs at the

View solution

Q. Modified moment of inertia of sections with a single web, is equal to moment of inertia of the section about Y-Y axis at the point of maximum bending moment and is multiplied by the ratio of

View solution

Q. According to IS: 800-1962, the coefficient of expansion of steel per degree centigrade per unit length, is taken as

View solution

Q. For a cantilever beam of length L continuous at the support and unrestrained against torsion at the support and free at the end, the effective length l is equal to

View solution

Q. On steel structures the dead load is the weight of

View solution

Q. The net area of round bars to resist the tension, is the area of cross section at

View solution

Q. The least permissible clear dimension of the web of thickness t in the panel of a plate girder, is restricted to

View solution