Q. The minimum width B of a solid casing for a cased beam, is equal to

View solution

Q. Rise of a Jack arch is kept about

View solution

Q. Pick up the correct statement from the following:

View solution

Q. In factory buildings, the horizontal beams spanning between the wall columns supporting a wall covering, are called

View solution

Q. If the thickness of a structural member is small as compared to its length and width, it is classified as

View solution

Q. The effective length of a compression member of length L held in position at both ends but not restrained in direction, is

View solution

Q. Tacking rivets in tension members, are provided at a pitch in line not exceeding

View solution

Q. Rolled steel beams are :

View solution

Q. Long column is one

View solution

Q. For a single section used as a tension member, the given area is assumed

View solution

Q. A beam may be designed as a cased beam if

View solution

Q. Compression members composed of two channels back-to-back and separated by a small distance are connected together by riveting so that the minimum slenderness ratio of each member between the connections, does not exceed

View solution

Q. For steel members exposed to weather and not accessible for repainting, the thickness of steel should not be less than

View solution

Q. If N is the number of rivets in the joint, the strength of a riveted joint against shearing of rivets, is given by

View solution

Q. If the area of cross-section of a single angle discontinuous strut is 30 cm² and allowable working stress corresponding to its slenderness ratio is 625 kg/cm², the safe load carrying capacity of the member, is

View solution

Q. Maximum permissible slenderness ratio of compression members which carry dead and superimposed load, is

View solution

Q. Pick up the correct statement from the following:

View solution

Q. When the depth of a plate girder is at least n times the depth of vertical leg of the flange angles, the girder is known as deep plate girder, if n is

View solution

Q. The side thrust T on the tie rods provided at the end beam of jack arch of rise R, is calculated from the formula

View solution

Q. If d is the distance between the flange angles,

View solution