Q. Compression members composed of two channels back-to-back and separated by a small distance are connected together by riveting so that the minimum slenderness ratio of each member between the connections, does not exceed

View solution

Q. A beam may be designed as a cased beam if

View solution

Q. For a single section used as a tension member, the given area is assumed

View solution

Q. Long column is one

View solution

Q. Rolled steel beams are :

View solution

Q. Tacking rivets in tension members, are provided at a pitch in line not exceeding

View solution

Q. The effective length of a compression member of length L held in position at both ends but not restrained in direction, is

View solution

Q. If the thickness of a structural member is small as compared to its length and width, it is classified as

View solution

Q. In factory buildings, the horizontal beams spanning between the wall columns supporting a wall covering, are called

View solution

Q. Pick up the correct statement from the following:

View solution

Q. Rise of a Jack arch is kept about

View solution

Q. The minimum width B of a solid casing for a cased beam, is equal to

View solution

Q. Design of a riveted joint is based on the assumption:

View solution

Q. A web plate is called unstiffened if the ratio of clear depth to thickness is less than

View solution

Q. Pick up the correct statement from the following:

View solution

Q. In a grillage footing, the maximum shear force occurs at the

View solution

Q. Modified moment of inertia of sections with a single web, is equal to moment of inertia of the section about Y-Y axis at the point of maximum bending moment and is multiplied by the ratio of

View solution

Q. According to IS: 800-1962, the coefficient of expansion of steel per degree centigrade per unit length, is taken as

View solution

Q. For a cantilever beam of length L continuous at the support and unrestrained against torsion at the support and free at the end, the effective length l is equal to

View solution

Q. On steel structures the dead load is the weight of

View solution