Q. In a tension member if one or more than one rivet holes are off the line, the failure of the member depends upon :

View solution

Q. The size of a butt weld is specified by the effective throat thickness which in the case of incomplete penetration, is taken as

View solution

Q. The thickness of the web of a mild steel plate girder is less than d/200. If only one horizontal stiffener is used, it is placed at

View solution

Q. The load on a lintel is assumed as uniformly distributed if the height of the masonry above it, is upto a height of

View solution

Q. Working shear stress on the gross area of a rivet as recommended by Indian Standards, is

View solution

Q. Pick up the correct statement from the following:

View solution

Q. Stiffeners are used in a plate girder

View solution

Q. The channels get twisted symmetrically with regard to its axis

View solution

Q. The stiff portion of a bearing stiffener is taken equal to

View solution

Q. Effective length of a column effectively held in position at both ends and restrained in direction at one end, is

View solution

Q. The strength of ISA 125 = 75 x 10 mm used as a tie member with its longer leg connected at the ends by 27 mm diameter rivets, is

View solution

Q. Cold driven rivets range from

View solution

Q. The main type of butt joints, is a double cover

View solution

Q. Outstanding length of a compression member consisting of a channel, is measured as

View solution

Q. The equivalent axial load may be defined as the load which produces a stress equal to

View solution

Q. If d is the distance between the flange angles of a plate girder, vertical stiffeners are provided at a distance not greater than

View solution

Q. The beam outside a wall upto floor level above it, is known as

View solution

Q. A structural member subjected to tensile force in a direction parallel to its logitudinal axis, is generally known as

View solution

Q. For the economical design of a combined footing to support two equal column loads, the projections of beams in lower tier are kept such that bending moment under column is equal to

View solution

Q. In rolled steel beams, shear force is mostly resisted by

View solution