Q. The ratio of hydrostatic stress to the volumetric strain within the elastic range, is called

View solution

Q. The deflection of beams may be decreased by

View solution

Q. For a cantilever beam of length L built-in at the support and restrained against torsion at the free end, the effective projecting length l is

View solution

Q. In a built up section carrying a tensile force, the flanges of two channels are turned outward

View solution

Q. If P is the wind pressure in kg/cm², v is the velocity in km/hour and K is a constant of proportionality, then

View solution

Q. Length of an outstanding leg of a vertical stiffener, may be taken equal to

View solution

Q. Efficiency of a riveted joint is defined as the ratio of

View solution

Q. The stress in the wall of a thin cylinder subjected to internal pressure, is

View solution

Q. The diameter of a bolt hole is taken as the nominal diameter of the bolt plus

View solution

Q. Pick up the correct statement from the following:

View solution

Q. According to I.S. : 800 - 1871, lacing bars resist transverse shear equal to

View solution

Q. The greatest permissible clear dimension of the web of thickness t in the panel of a plate girder, is restricted to

View solution

Q. As per ISI, rolled steel beam sections are classified into

View solution

Q. Water pressure in a 80 cm water main is 10 kg/cm². The minimum thickness of the metal required for the water main, not to be stressed more than 200 kg/cm², is

View solution

Q. In a tension member if one or more than one rivet holes are off the line, the failure of the member depends upon :

View solution

Q. The size of a butt weld is specified by the effective throat thickness which in the case of incomplete penetration, is taken as

View solution

Q. The thickness of the web of a mild steel plate girder is less than d/200. If only one horizontal stiffener is used, it is placed at

View solution

Q. The load on a lintel is assumed as uniformly distributed if the height of the masonry above it, is upto a height of

View solution

Q. Working shear stress on the gross area of a rivet as recommended by Indian Standards, is

View solution

Q. Pick up the correct statement from the following:

View solution